Hellhound kit question.

[imperialsavant]

G'day All!
Could anyone on the Forum who has built a new Hellhound please tell me the size of the hole the Turret attaches to?

I was thinking I could maybe swap with a T/L Autocannon from the Planetstrike kits to allow me to use it as either a Hellhound or a Hydra depending on my requirements.

Any answers gratefully accepted! :confused:

[faolan]

The hole on the Hellhound is a bit small at approx 12mm. The Planetstrike Autocannon and Lascannon fit relatively well onto the Rhinos if you use the Pred/Razorback/Whirlwind top plate, but not on the Hellhound, etc.

Now on the Hellhound if you cut out the raised area that the turret sits on, it should work, as that's about 23-24mm.

[crazyredpraetorian]

You could always do this or something similar.

http://c4.ac-images.myspacecdn.com/images02/8/l_5aeb6aebeda0499bbebbaf87e6178d63.jpg

[imperialsavant]

;) Thanks for the info & suggestions, guys!