Asymmetrical Xeno
11-26-2012, 11:04 AM
I've been procrastinating with this for a whole year now, that's terrible - but it's mainly because I have no idea how to do it properly and I'm afraid of messing it up.
I need to be able to cut very thick (say 2-3mm thick) plasticard, as well as very precise shapes and I have no idea what tools to use so I'm wondering if the kind folks on BOLS will be able to give me some good advice, recomend any specific tools ect.
As an example, I need to cut all the shapes you see on this :
http://i196.photobucket.com/albums/aa207/embodiedscrew/TILE01_Runic_Wall-1.jpg
I have about a dozen of these tile designs I need to make, the size is also roughly similar to how big it should be in real life too. They'll be used to construct walls, floors and ceilings to build the sets for my sci-fi web show.
I need to be able to cut very thick (say 2-3mm thick) plasticard, as well as very precise shapes and I have no idea what tools to use so I'm wondering if the kind folks on BOLS will be able to give me some good advice, recomend any specific tools ect.
As an example, I need to cut all the shapes you see on this :
http://i196.photobucket.com/albums/aa207/embodiedscrew/TILE01_Runic_Wall-1.jpg
I have about a dozen of these tile designs I need to make, the size is also roughly similar to how big it should be in real life too. They'll be used to construct walls, floors and ceilings to build the sets for my sci-fi web show.