Swappable weapons for Chaos SM

[DadExtraordinaire]

Hi all,

Can anyone recommend the best solution for allowing swappable weapon load-outs for Chaos SM that will not lift paint off the figure? I did consider magnets but I feel the process is far too fiddly on the hands and guns.

Thanks in advance.

[isotope99]

You can always manetize at the shoulder and have them held onbe handed, otherwise you are probably looking at a drill and pin approach.

[DadExtraordinaire]

You can always manetize at the shoulder and have them held onbe handed, otherwise you are probably looking at a drill and pin approach.

Not a bad idea, I might try that instead....many thanks for the helpful suggestion.

[Thorsson]

If you are talking about just switching out assault weapons and bolters then I have a solution.

-Find a small paper clip and a drill bit that is slightly larger than the diameter of the clip.
-Drill a hole in the hand that holds the handle and trigger.
-Cut a piece of the clip and file both sides flat.
-Glue the piece of clip into the hand.
-Drill holes in the weapons you want to switch out.

And there you go. If you want some examples I can post some. :D